
Custom Spray 5-in-1 Gloss Clear Spray Paint (Case of 6). But given a few months of hardening time, it ends up harder than any other paint I know. Read page 4 of our customer reviews for more information on the Rust-Oleum Stops Rust 12 oz. If you get it right, the brush strokes will level out and the hammered appearance will start to show up perhaps a minute after you've brushed the area.Īlso, be aware that it stays pretty soft for a long time.

Just be careful around corners and places where extra paint may want to stick until it drips into a run. If you thin it, you'll end up with runs and may even orangepeel. So, what sort of issues are you having? The brush on Hammertone needs to go on pretty thick for the hammer dents to develop without pin holing. If you really need a thinner paint, get the spray on Hammertone. While a Purdy XL-Glide (one of my favorites in blended polyester bristles) will say it is for all paints (their Nylox is only for water based paints), and even claims it is stiff, it is still far too soft for Hammertone. Hammertone brush on paint is very thick, and I find that it needs a natural bristle brush (white china bristle) to match its viscosity. What kind of Purdy brush? They make all sorts. If I were doing a BIG surface I was really concerned about getting a uniform finish on I'd use a big roller. I've seen 12" and (I think) an 18" roller at Home Depot.
DOES RUST OLEUM SPRAY PAINT RUN FULL
For large surfaces - like a cabinet, I'd roll it with a full 9" roller.

This is somehow the way the paint develops the hammer finish. I dusted it off and that's all.īut for the workbench top - it's hard to gets "sticky" almost immediately. That worked fine on the I beams in the photo above. I used a little $2.79, 2-1/2" foam roller.

I spilled some on the bench top, did a half-assed wipe off with a dry paper towel and left it. I recently used some Ospho - which is phosphoric acid for eliminating rust on metal. Rust-Oleum Antique White Chalky Finish Furniture Matt Paint 750ml. I later applied it to a wood workbench top - 1 coat. Rust-Oleum Chalk White Chalky Finish Furniture Matt Paint 750ml. I applied two coats the steel beam structure above.
